iX Talk
http://beijerinc.com/support/ix/forum/

How can be accessed the QTERM-A7 SERVICE MENU
http://beijerinc.com/support/ix/forum/viewtopic.php?f=11&t=142
Page 1 of 1

Author:  RestaLG [ Mon Feb 13, 2012 2:56 am ]
Post subject:  How can be accessed the QTERM-A7 SERVICE MENU

Sorry for my english...

manual says:

Quote:
The service menu for the operator panel can be accessed before a project is downloaded, or by setting the mode switches in mode 1000. The location of the mode switches is described in the installation manual for the operator panel.


When I still have in operator panel downloaded project, i am not be able to access the service menu for calibrate touch screen, here is not any switches...

How I do it? thanks very lot.

Author:  Skylar [ Tue Feb 14, 2012 5:33 pm ]
Post subject:  Re: How can be accessed the QTERM-A7 SERVICE MENU

Press and hold your finger on the screen while applying power. Hold you finger on it until the calibration screen appears. You can then follow the instructions on the screen.

Author:  RestaLG [ Wed Feb 29, 2012 2:57 am ]
Post subject:  Re: How can be accessed the QTERM-A7 SERVICE MENU

Thanks for your answer, it is good method - tested.

Author:  Franswa [ Mon Feb 22, 2016 12:57 am ]
Post subject:  Re: How can be accessed the QTERM-A7 SERVICE MENU

Hello,
Is it possible to add a button to access to the calibrate touch or a c# code to enable this whithout to press the screen to the start.
best regards.

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/