iX Talk
http://beijerinc.com/support/ix/forum/

iX T15BM connected to DOT MATRIX Printer Epson/USB or Serial
http://beijerinc.com/support/ix/forum/viewtopic.php?f=11&t=1805
Page 1 of 1

Author:  iosif [ Tue Nov 11, 2014 9:42 am ]
Post subject:  iX T15BM connected to DOT MATRIX Printer Epson/USB or Serial

Hello everybody,

I try to connect the T15BM with a dot matrix printer via USB but I am not sure that if it is supported as its printing method is dot matrix.

Also, I tried to connected it serial from COM2-RS422 via the Beijer BDC-JetCon RS422toRS232 converter but without success. I don't understand where should I connect the DTR signal from the Printer.

At the past I connected the Exter series with this printer via the CAB6 cable.
But now the iX series has 9-pin RS422 and not 25-pin.

I would appreciate any help.

Author:  JohnCZ [ Thu Dec 04, 2014 7:22 am ]
Post subject:  Re: iX T15BM connected to DOT MATRIX Printer Epson/USB or Se

Hi,

Because Windows Embedded CE has only a PCL printer driver, the following registry key entry is hard-coded into the registry to load the PCL driver. This enables testing all USB printers that support PCL print format.

Non-PCL printers still support ASCII-only printing with the default PCL driver.
To support printing on non-PCL printers,
Therefore, the printer driver shows up in Microsoft® WordPad for Windows Embedded CE word processing software with LPT1:

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/