Welcome Guest ( Login | Register )



All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: iXT7B communication Break issue with Fx3U PLC
PostPosted: Sun Feb 02, 2014 11:46 pm 

Joined: Tue Feb 26, 2013 3:58 am
Posts: 10

Offline
Dear Sir/Ma'am

We are facing communication break issue in iXT7B and FX3U PLC in following conditions.
1.In proper communication condition when you switch off iX panel and again power ON it after 1Hr or so, "comm. error" is displaying on screen. Then you need to connect and disconnect communication cable several times to start communication again. Same issue on both com2 and com4 port.
2.We also done self test after communication break. Please check self test result attached.
3.please find attachment for Communication parameter set in iX panel settings. Cable configuration is also proper.

So please let us know
Is it hardware issue? or any other settings required for the same.

thanks in advance.


Attachments:
File comment: Controller Setting in iX Panel
Settings1.gif
Settings1.gif [ 41.13 KiB | Viewed 3062 times ]
File comment: iX Panel Self Test Snap2
IMG-20140121-WA0002.jpg
IMG-20140121-WA0002.jpg [ 48.58 KiB | Viewed 3062 times ]
File comment: iX Panel Self Test Snap1
IMG-20140121-WA0001.jpg
IMG-20140121-WA0001.jpg [ 47.95 KiB | Viewed 3062 times ]
 Profile  
 
 Post subject: Re: iXT7B communication Break issue with Fx3U PLC
PostPosted: Fri Apr 25, 2014 9:39 am 

Joined: Thu Jun 06, 2013 9:21 am
Posts: 61

Offline
Please provide a wireshark or serial comm printout and send it into support@beijerinc.com

Thank you.


 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 7 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: