Welcome Guest ( Login | Register )



All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Connecting omron plc through ix t7a
PostPosted: Thu Jul 03, 2014 1:42 am 

Joined: Fri Jun 27, 2014 1:41 pm
Posts: 1

Offline
Hi,

I have omron cj1m cpu11 plc and ix t7a panel. They comminicate with rs232 cable. I want to connect to my plc through ix t7a, and i didn't succeed.
I am using fins protocol and ix t7a panel communicates well with plc.There is no problem. When i try to connect from cx-programmer(omron plc software) to plc, it writes on the panel ''controller1:passthrough ''. Then cx-programmer says ''selected port does not exist'' .
My question is did you try to connect to omron plc's this way? If you did, pls give me hand.


Attachments:
fins ayar3.jpg
fins ayar3.jpg [ 56.98 KiB | Viewed 2433 times ]
fins ayar2.jpg
fins ayar2.jpg [ 55.46 KiB | Viewed 2433 times ]
fins ayar1.jpg
fins ayar1.jpg [ 58.17 KiB | Viewed 2433 times ]
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 7 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron