Welcome Guest ( Login | Register )



All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: No working driver for Fanuc Robotics?
PostPosted: Tue Feb 03, 2015 3:07 am 

Joined: Tue Feb 03, 2015 1:50 am
Posts: 1

Offline
Will try again, my last post dissapeared. :(

I have serious problems with data transfer between my iX T15b panel, and the Fanuc Robot controller 30iB. Digital I/O works well, but data registers are not working properly. (driver GE/Fanuc Ethernet via SRTP)
Problem 1: It´s not possible to send decimal values. The values will be rounded up/down to closest number. This causes lot of problems.
Problem 2: Data registers cannot be more than 4 digits. This is very big problem. Register handling will be unusable!

Answers on that from Beijer? Is this driver tested with Fanuc Robots?

Fanuc support says that this must be caused by the driver (GE Fanuc is an old PLC system, and shall not be compared and not simlilar to Fanuc Robotics)


 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 7 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron