iX Talk
http://beijerinc.com/support/ix/forum/

Modbus use of preset holding register (function 0x10)
http://beijerinc.com/support/ix/forum/viewtopic.php?f=5&t=2046
Page 1 of 1

Author:  charlyprouteau [ Thu Feb 25, 2016 9:57 am ]
Post subject:  Modbus use of preset holding register (function 0x10)

Dear sir,
I use modbus master controller.
I would like to write some UINT16 with function code 0x10.
For example, I would write 5 UINT16:
40001
40002
40003
40004
40005
When I modified the value of each register, each register are sent one by one :
one request per register with function code 0x10. I also tryed to modified the register values by Scripting but same result.
I can use UINT 32 to send two registers but how can I do to writemore than 2 registers.
Regards,

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/