iX Talk
http://beijerinc.com/support/ix/forum/

How to capture a button raise edge for Vigor VB controller?
http://beijerinc.com/support/ix/forum/viewtopic.php?f=5&t=2110
Page 1 of 1

Author:  raoleon [ Wed Jul 27, 2016 9:19 pm ]
Post subject:  How to capture a button raise edge for Vigor VB controller?

How to config a button (link to PLC M address) to make the controller capture the raising edge of it?

I'm trying to immigrate a ADP/H-designer project to ix panel without changing the PLC program. The old platform have some momentary buttons which triggers the PLC addresses on the raising edge. But iX pannel seems fail to give the rasing edge signal to the controller.

Is there any way to slove the issue?

I made a sample project which shows how I config the button now.

Attachment:
File comment: PLC sample
2016-7-28 11-00-10.png
2016-7-28 11-00-10.png [ 14.14 KiB | Viewed 2403 times ]


Attachment:
ButtonTest.zip [88.7 KiB]
Downloaded 126 times

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/