Welcome Guest ( Login | Register )



All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: How to capture a button raise edge for Vigor VB controller?
PostPosted: Wed Jul 27, 2016 9:19 pm 

Joined: Thu Sep 10, 2015 1:56 am
Posts: 2

Offline
How to config a button (link to PLC M address) to make the controller capture the raising edge of it?

I'm trying to immigrate a ADP/H-designer project to ix panel without changing the PLC program. The old platform have some momentary buttons which triggers the PLC addresses on the raising edge. But iX pannel seems fail to give the rasing edge signal to the controller.

Is there any way to slove the issue?

I made a sample project which shows how I config the button now.

Attachment:
File comment: PLC sample
2016-7-28 11-00-10.png
2016-7-28 11-00-10.png [ 14.14 KiB | Viewed 2407 times ]


Attachment:
ButtonTest.zip [88.7 KiB]
Downloaded 126 times


 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 7 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron