How to transfer a project in iX Developer to an iX operator terminal using a portable USB flash drive.
Open your project in iX Developer. Under the "Project" tab, select the "Transfer" button that has a folder icon.
Attachment:
transfer_icon.JPG [ 19.68 KiB | Viewed 9406 times ]
Select the folder where the USB flash drive is located and press OK.
Attachment:
select_folder_ok.JPG [ 43.13 KiB | Viewed 9406 times ]
This creates a directory called "Project" where an executable and DLL's needed by the operator terminal are stored. Source code is not copied to this folder.
Attachment:
project_explore.JPG [ 47.36 KiB | Viewed 9406 times ]
Remove the USB flash drive from your PC and insert into an iX operator terminal that is turned off.
Apply power to the terminal. A dialog will appear for a few seconds during start up with the text
Quote:
Copy project from USB memory?
Select "Yes" before the dialog disappears. If you do not press "Yes" in time, cycle the power on the terminal and try again.
Wait while the project is copied from the USB stick and loaded. This can take a few minutes.